Ejection Baffles

Back to Build Supplies
Back to Build Supplies
Baffles are used to eliminate the need for recovery wadding in a model rocket. To install one in a new rocket that uses a coupler, simply install the assembled baffle kit instead of the coupler.

For existing rockets, you may still be able to install a baffle, depending on where the shock cord was initially installed. You'd want to glue the assembled baffle inside the airframe, towards the nose cone. Make sure you leave enough room for parachute, shock cord, and nose cone shoulder.

These baffles include laser-cut plywood wooden discs for optimal strength and durability.
   

BT-20 Baffle Kit with Shock Cord

BT-20 Baffle Kit with Shock Cord

Eection baffle kit for BT20 body tubes. Install to eliminate the need for recovery wadding. 2" Long. Includes: Baffle Kit 1/4" Shock Cord (30" Long) Thrust ring to reinforce the baffle in the tube (Optional) Requires: Assembly Plastic Cement Carpenters Glue (Needed, if installing the thrust ring)
$3.00

Add to Cart


BT-50 Baffle Kit

BT-50 Baffle Kit

Model rocket ejection baffle kit for BT50 body tubes. Install to eliminate the need for recovery wadding.
$3.45

Add to Cart


BT-55 Baffle kit - wood discs

BT-55 Baffle kit - wood discs

Upgrade your model rocket with this ejection baffle kit. Quality parts, such as the plywood discs. Fits BT55 airframe.
$3.55

Add to Cart


BT-60 Ejection Baffle kit - plywood discs

BT-60 Ejection Baffle kit - plywood discs

This is an ejection baffle kit for use with flying model rockets. Quality parts, including "Fish Paper" coupler. The assembled unit fits a BT60 airframe.
$3.95

Add to Cart


BT-80 Ejection Baffle Kit

BT-80 Ejection Baffle Kit

Never have to deal with recovery wadding again. Save on prep-time. This baffle kit is for use with BT80 model rocket body tubes. Includes plywood discs and kraft-paper coupler.
$4.75

Add to Cart


29mm Ejection Gas Baffle

29mm Ejection Gas Baffle

Includes 29mm anchor/baffle ring and the cooling mesh.
$2.20

Add to Cart


Cooling Mesh

Cooling Mesh

Make your own baffle! Use this cooling mesh in the motor mount tube to cool ejection gas down and block hot particles from reaching the parachute. make sure this mesh is blocked in the motor mount tube and that there is a sufficient gap between the mesh and the motor. It is the same mesh, which is...
$1.80

Add to Cart


<