Ejection Charge Parts

Dual Deployment
Modules

Recovery & other
hardware

Back to Build
Supplies

Use ejection holders and hardware below with CPR3000 style ejection system or to build your own deployment module.

Both the Charge Cylinders and the Holder are made of very durable and blast resistant urethane and can be re-used indefinitely. The Charge Cylinder snaps securely into the Holder. The powder is then held in place with a bit of wadding and a vinyl cap

The igniter is inserted into the hole near the bottom and is held in place by the internal geometry of the charge cylinder. The lead is then bent over toward the back of the cylinder, following the groove. The lead is then threaded into the hole in the bottom center of the holder and then through the altimeter mount. This routing method creates a labyrinth that the gasses cannot follow to the altimeter bay.